Starmobile Engage 7 Lite Hang On Logo Done Firmware/Tools

-rockchip usb drivers - http://www.cnx-software.com/2013/11/...-windows-xp78/

-Starmobile Engage 7 Lite

-PC knowledge

-knowledge handling zip

-patience



Procedure:

-MAKE A FULL BACKUP OF YOUR CURRENT ROM. (instructions to follow)

-MAKE SURE ROCKCHIP USB DRIVERS INSTALLED.

-download zip from link below

-extract contents then go to extracted folder

-run/execute AndroidTool.exe

-verify check marks. only parameter, misc,kernel,boot,recovery,system and backup should be checked.

----if Engage 7 Lite is ON, connect tab to usb(make sure drivers installed already), press swith to reboot into Loader mode.

----if Engage 7 Lite is OFF, hold VolUP while connecting usb cable. then check AndroidTool, should show "Found RKAndroid Loader"

-if asks for drivers, just locate them in drivers folder

-if already in flash mode(and androidtool detects), press LowerFormat(this wipes nand)

-then press RUN to start flashing. wait for it to finish. this will auto-reboot Engage 7 Lite when done and automatically do factory reset.

-when it boots successfully to homescreen, wait for about 5-10mins(standby nyu muna unit)

-check system>storage and see if phone storage is mounted. if not, format PHONE STORAGE (settings>storage) then reboot. then check if properly mounted na.

-(optional) do a factory reset so files/and folders will be properly created on internal storage/phone storage.

-Your Engage 7 Lite should now be fixed.


Firmware/Tools Download Link : https://mega.co.nz/#!qRBUXRLA!4tO4ib..._c2OJiZ9t7wy1s


at ito po nang dinala sakin Hang On Logo:



Flashing:



After Flashing:




Device Info:



Wifi:



Camera: