Cherry Mobile C8 PLDT / Smart locked... unlock done

Volcano Updated: 2013-05-22
Connecting...
Connection successful,connected state!
Version: V3.8
SN:268-683-966
Port:COM5
After format or Flash you have to press & hold power button for at least 1.30 mins.
Note for win7 users :
Start your Win 7 64bit with F8 key and choose 'Disable Driver Signature Enforcement'.
After that the spd drivers will have the ability to be loaded.
Available Ports:COM3 COM4 COM5 COM110
Detection initiated...
Vcc: null
Gnd: 21 23
Analyzing D+ and D-...
D+ = 19, D- = 17
Analyzing USB device, please wait...
Find USB device:SCI USB2Serial (COM64), (VID_1782&PID_4D00)


Internal version: Spreadtrum Boot Block version 2.0
Boot downloaded.
Start boot please wait a moment....
Spreadtrum Boot Block version 1.2
CPU TYPE:SC6610/20 [66100000]
FLASH ID: 00C8004000160000
Flash Type:[GD] GD25Q32
Size:0x400000(4MB)
Writing completed.
Flash file E:\_GSM BOX_\Volcano\Cherry Mobile\C8\MOCOR_09A_MP.W11.16_P7_Release_20130830_ 200915_*********.bin has been written.
Detection initiated...
Vcc: null
Gnd: 21 23
Analyzing D+ and D-...
D+ = 19, D- = 17
Analyzing USB device, please wait...
Find USB device:SCI USB2Serial (COM64), (VID_1782&PID_4D00)


Internal version: Spreadtrum Boot Block version 2.0
Boot downloaded.
Start boot please wait a moment....
Spreadtrum Boot Block version 1.2
CPU TYPE:SC6610/20 [66100000]
FLASH ID: 00C8004000160000
Flash Type:[GD] GD25Q32
Size:0x400000(4MB)
Writing completed.
IMEI has been written.
Ready to read/write again, please remove the power supply clip or battery and then re-loaded it.
Detection initiated...
Vcc: null
Gnd: 21 23
Analyzing D+ and D-...
D+ = 19, D- = 17
Analyzing USB device, please wait...
Find USB device:SCI USB2Serial (COM64), (VID_1782&PID_4D00)

Internal version: Spreadtrum Boot Block version 2.0
Boot downloaded.
Start boot please wait a moment....
Spreadtrum Boot Block version 1.2
CPU TYPE:SC6610/20 [66100000]
FLASH ID: 00C8004000160000
Flash Type:[GD] GD25Q32
Size:0x400000(4MB)
>>Set to Factory successfully.1. Box settings

SPD tab
built-in boot_02
check auto pinouts (USB d+/D-)

2.use P-10c adoptor
3.write flash (use back-up file from openline C8)
4.write orig imei
5.format